PC/CP364 Data Communications and Networks laboratory

SPI DAC Postlab Requirements

Postlab Requirements

  1. Show the mapping between the pin numbers on the Arduino board and the corresponding pins on the MAX522 chip.
  2. Create the illustration for SPI D/A Converter
    Note that this will require combining the two scope traces you have. Since the chip select signal is the simplest, add this to the trace showing the other two lines.
  3. Submit these and your modified Arduino sketch to the lab instructor at next week's lab.


To view pdf documents, you can download Adobe Acrobat Reader .
get Acrobat Reader
If you need to update a browser, you might try Firefox which is Get Firefox!
Since this page uses cascading style sheets for its layout, it will look best with a browser which supports the specifications as fully as possible.

If you are looking for an office package, with a word processor, spreadsheet, etc., you might try LibreOffice which is Get LibreOffice!

Go to the main page for the Department of Physics and Computer Science.

Valid XHTML 1.1

Valid CSS!

(Level AA)

Wilfrid Laurier University